MAGNUS INTERNATIONAL LIMITED
A trust medical supply source from China!
Add to Cart
Looking for COVID-19 Antigen Fast Test 5 boxes packing?
Yes, we have!
【PRODUCT NAME】
SARS-CoV-2 (COVID-19) Antigen Rapid Test Kit(Colloidal Gold)
【SPECIFICATION】
1 test/kit;20 tests/kit; 25 tests/kit; 50 tests/kit.
【INTENDED USE】
This kit is intended to be used for the qualitative detection of SARS-CoV-2 antigen in human respiratory
specimens, sputum, and other samples. This kit uses cellulose membrane immunochromatography technology.
Antigen detection is used for auxiliary diagnosis or epidemiological investigation of human infection
with SARS-CoV-2.
| Components | 1T | 20T | 25T | 50T |
| 1. SARS-CoV-2 test card | 1 PIECE | 20 PIECES | 25 PIECES | 50 PIECES |
| 2. Disposable sampling tube(with sample diluent buffer) | 1 PIECE | 20 PIECES | 25 PIECES | 50 PIECES |
| 3. Disposable sampler | 1 PIECE | 20 PIECES | 25 PIECES | 50 PIECES |
| 4. Instructions | 1 COPY | 1 COPY | 1 COPY | 1 COPY |
Note: The components in the kits of different batch numbers are not interchangeable.
The materials and instruments necessary for the test but not provided are as follows:
Lancet;
Absorbent paper or similar material;
Timer;
Micropipette corresponding to the range;
Laboratory safety protection equipment such as disposable gloves, etc.
【EXPERIMENT WORKFLOW】
Please read the instruction for use carefully before using this kit. All reagents should be incubated at room
temperature (10-30°C) for 30 minutes prior to use. The test should be carried out at room temperature and the
operation procedure is described below:
1. Open the sealed bag and remove the Detection Strip. Mark the sample ID on the test strip and lay the strip
flat on the table.
2. Specimen collection
1). Carefully insert the swab into the nostril of the patient, reaching the surface of posterior nasopharynx,
that presents the most secretion under visual inspection.
2). Swab over the surface of the posterior nasopharynx. Rotate the swab several times.
3). Withdraw the swab from the nasal cavity.
3. Sample preparation
1). Insert the sample diluent tube into the pipe rack, make sure that the tube is standing firm and reaches
the bottom of the pipe rack.
2). Open the purple cap of the sample diluent tube. Insert the swab into the diluent tube which contains
0.5 mL of the diluent buffer. Roll the swab at least 6 times while pressing the head against the bottom
and side of the diluent tube.
3). Leave the swab in the diluent tube for 1 minute.
4). Squeeze the tube several times with fingers from outside of the tube to immerse the swab. Remove
the swab,close the cap. The diluent solution will be used as test sample.
5). Open the small cap on the top of the sample dilution tube. Add 3-4 drops (~100 μL) of the sample
diluent buffer immediately to the sample well.
6). Allow the strip to develop for 10-15 minutes at room temperature. A visible band can be read by
naked eyes.
【EXPORTER】
Magnus Internationa Limited
F12, New City Internationa Mansion A, 234 Huapao Ave.
Liuyang, Hunan Province 410300 China
Contact: Goodwell@gmail.com
【AUTHORIZED REPRESENTATIVE】
Lotus NL B.V.
Koningin Julianaplein 10, 1e Verd, 2595AA, The Hague, Netherlands.